|
| |
|
|
| Question 1 |
|
The LCD is faint. |
| |
|
|
| |
|
1. Set the LCD contrast to a higher level.
2. Replace the batteries
|
| |
|
|
Section 2 - Outdoor Temperature
|
| |
|
|
| Question 1 |
|
No outdoor temperature is displayed |
| |
|
|
| |
|
- Remove all batteries, reinsert into the remote temperature sensor first, then into the indoor weather station.
- Place remote temperature sensor closer to the indoor weather station.
- Be sure all batteries are fresh.
- No other interfering sources are being used (such as computer monitors, TV sets, headphone, or speakers) in the vicinity. The signal travels in a straight line, and electrical source near that "line" may cause interference.
|
| |
|
|
| Question 2 |
|
Outdoor Temperature Display Incorrect |
| |
|
|
| |
|
Once the outdoor temperature reaches approximately 113°F, the wireless transmission will cease until the temperature drops.
If the receiver is wired to the sensors, the system will continue to work up to 120°F or higher. |
| |
|
|
Section 3 - Time and Date
|
| |
|
|
| Question 1 |
|
No reception of WWVB time signal |
| |
|
|
| |
|
- Wait until overnight for signal to be received
- Be sure indoor weather station is at least 6 feet from any other electrical devices such as televisions, computers, or other radio-controlled clocks.
- Remove the batteries for five minutes, reinsert and leave the unit alone overnight without pressing any buttons.
- If there is a consistent problem, please contact us via email at support@lacrossetechnology.com or by phone at
1-888-211-1923
|
| |
|
|
| Question 2 |
|
Hour is incorrect (minute and date are correct) |
| |
|
|
| |
|
Be sure correct time zone and daylight saving time is selected. |
| |
|
|
| |
|
Note: If you continue to have problems, please contact our support line at 1-888-211-1923 or support@lacrossetechnology.com for more information. |
| |
|
|
